Universal Devices ISY-994i Series, User Manual

Page: 414 / 692

Page | 391
Figure 239: Press and Hold the Set button for 5 seconds
•
Click OK.
•
Wait while the ISY initializes communications with the TriggerLinc.
13.21.1.1TriggerLinc FAQs
•
To access the TriggerLinc, one or more Access Points must be installed.
o
Tip: Plug an Access Point into the PLM for positive results.
•
The Set button toggles between Off and On.
•
The TriggerLinc must be “awake” to hear messages.
o
Tip: Put the TriggerLinc into linking mode to keep it awake for 4 minutes.
o
The TriggerLinc can be taken out of linking mode by pressing the Set button
twice.
14 X-10 Device Notes
14.1 Tracking X-10 Device Status
71
As of firmware 2.7, ISY does not maintain the status of X-10 devices, as it does for INSTEON
devices. Furthermore, unlike INSTEON devices, most X-10 devices are not two-way devices,
and therefore cannot be queried for status. However, the user may maintain the status of
individual X-10 devices using a program triggered by commands which turn the device on
and off. [Note: As of firmware 2.6.4, X-10 commands sent from ISY are treated as events
and will therefore update the program status appropriately.] The simplest such program
might look like this:
14.1.1 Program X-10 D4 Status
If
X10 'D4/On (3)' is Received
And X10 'D4/Off (11)' is not Received
Then
- No Actions - (To add one, press 'Action')
Else
- No Actions - (To add one, press 'Action')
71 (Universal Devices)