![background image](http://html1.mh-extra.com/html/univers-by-fte/u4110/u4110_user-manual_845774032.webp)
PAG
.
32
rev 1.1
English
SYSTEM SETUP
5.6. LNB POWER
Here you can set the power output to the LNB (OSD 72). If
your receiver is connected to the LNB directly then you need to
set the LNB Power to “On”. If your receiver is connected to a
multi switch (SMATV signal distribution system) then it may be
that you don’t need to provide the power to the LNB. But since
this is depending on the kind of installed distribution system we
recommend you to contact your installer or to refer to the user
manual of this system to get the correct information.
You also just can change this setting and check if you still can
receive the channels. If the LNB Power is off and you still can
see all channels then we recommend this setting.
5.7. RCU POSITION SWITCH
In order to avoid interferences between remote controls, you
have the possibility to change the code of it, to do that you have
to change the position of a switch in the remote control.
But first of all you have to change this code in the receiver. You
can do this in the menu “RCU Position” (OSD 73).
You have to select the same position in the receiver than in the
remote control (OSD 74).
OSD 72
OSD 73
OSD 74
Summary of Contents for U4110
Page 1: ...U4110 ...