©Copyright 2020, UNITY Tactical. All Rights Reserved.
STANDARD / SYNC
1
Press Baseplate onto Control Module, ensuring edges line up.
2
Place Bolts through holes in top of assembly and begin
threading M-LOK™ Nuts onto them. DO NOT TIGHTEN.
3
Install TAPS™ to M-LOK™ or Key Mod™ Rail.
Lightly snug all screws before applying torque to
any. DO NOT EXCEED 35 IN-LBS ON METAL RAIL,
OR 15 IN-LBS ON POLYMER RAIL. Ensure M-LOK
™ nuts are fully perpendicular to slots in rail
(fully seated).
WARNING: Over-torquing fasteners can damage your mount and will not be covered by warranty.
M-LOK™ / Key Mod RAIL INSTALLATION
4
Route cables from TAPS™ to light and laser device, and
fully seat plug in sockets. Avoid sharp bends in cables
and routing over extreme heat areas and sharp edges.
