3/15
V100-17-CAN,V100-S-CAN
4
Unitronics
Installation in a SM70 controller
Opening the Controller
1.
Open the door marked
“Battery & Communication Module
Cover”,under the arrow direction.
2.
Break the plastic tab marked X.
3.
Plastic tab X comprises a cutout that
covers the CANbus port location.
Installing V100-17-CAN, V100-S-CAN
1.
locate the black plastic pin.
2.
Install the module as shown in the
accompanying figure 6-pin female CANbus
connector.The main board comprises a
male 6-pin CANbus connector
Caution
Make certain that the pins fit correctly
into their matching receptacle
Closing the controller
1. Close the controller by closing the Door
marked “Battery & Communication Module
Cover” back in its place.
The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its
sole discretion, and without notice, to discontinue or change the features, designs, materials and other specifications of its products, and to either
permanently or temporarily withdraw any of the forgoing from the market.
All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied
warranties of merchantability, fitness for a particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the
information presented in this document. In no event shall Unitronics be liable for any special, incidental, indirect or consequential damages of any kind,
or any damages whatsoever arising out of or in connection with the use or performance of this information.
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G)
Ltd. or other third parties and you are not permitted to use them without the prior written consent of Unitronics or such third party as may own them
DOC14002-A9 03/15
