2/15
V100-17-RS4/X, V100-17-ET2, V100-S-ET2, V100-17-PB1
4
Unitronics
Only V430/SM43
1.
Break the plastic tab marked PORT 2.
2.
Install the module as shown in the
accompanying figure.
Only SM70
1.
Install the module as shown in the
accompanying figure.
Closing the controller
1. Replace the I/O board.
2. Close the controller by snapping the plastic cover
back in its place. If the card is placed correctly,
the cover will snap on easily.
3. Replace the screws in the corners of the back
cover.
Only SM70
4. Close the controller by closing the Door marked
“Battery & Communication
Module Cover” back in its place.
The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its
sole discretion, and without notice, to discontinue or change the features, designs, materials and other specifications of its products, and to either
permanently or temporarily withdraw any of the forgoing from the market.
All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied
warranties of merchantability, fitness for a particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the
information presented in this document. In no event shall Unitronics be liable for any special, incidental, indirect or consequential damages of any kind,
or any damages whatsoever arising out of or in connection with the use or performance of this information.
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G)
Ltd. or other third parties and you are not permitted to use them without the prior written consent of Unitronics or such third party as may own them
DOC14001-C1 03/15
