Control connections
39
Version: 2019 / V05
BAMOCAR-D3-700-100/160
CAN
-B
US
5.8
CAN-BUS
The CAN-BUS is a digital connection to the CNC control.
Optimum conditions are achieved with CNC controls and CAN components of LABOD electronic or
CAN Open.
Programming and operation by means of the control panel via the CAN-BUS.
Interface complies with the standard ISO 11898.
Adjustment and programming see Manual NDrive and CAN Manual.
CAN BUS CABLE
Use a shielded bus conductor with a low
shielding capacity.
LiYCY 3 x 0.25 + shield
.
Designation
Connector Cable colour Cable no.
CAN-H
X1:31,32
green
3
CAN-L
X1:33,34
yellow
2
CAN-GND
X1:35
white
1
Shield
X1:1
CAN BUS Connection with multipleBAMOCAR-D3-700-160
Master
Address xx
Address xx
Address xx
Terminating resistor at the end of the bus line > 120 Ohm between CAN-H and CAN-L.
1
24
35
12
13
23
35
34
31
CAN-GND
CAN-L
CAN-H
32
CAN-H
33
CAN-L
