OPERATING:
1.
Make sure that the floor brush or cleaner nozzle are properly assembled, according to the
intended use.
2.
Roll out the cable and connect the plug to an appropriate power supply socket.
3.
Press the start button and slide it to “I”. The unit will start to operate.
CLEAN:
1.
After each use, place the switch to “0” and disconnect the plug from the mains.
2.
Always allow the appliance to cool down before storing.
3.
Remove the floor brush or vacuum cleaner nozzle.
4.
To empty the dust box press the release button - the bottom compartment will open and
you can release the content. CAUTION: Make sure to do this when you are positioned over a
waste container.
Note: Empty the compartment when you see that it is full.
CLEANING THE FILTER:
Before cleaning, make sure the device is powered off and the cord is unplugged. Always
operate the cleaner with the filter installed.
The filter must be washed at least 2 times a year or more often if dirty.
1.
Allow the appliance to cool down before cleaning.
2.
Remove the filter and clean it under running tap water.
3.
Tap the filter to remove thoroughly any water remaining in the filter and let it dry
completely for 24 hours before refitting into the device.
IMPORTANT: DO NOT CLEAN YOUR FILTER IN THE WASHING MACHINE AND DO NOT
USE THE HAIR DRYER FOR DRYING IT.
IMPORTANT: THE FILTER MUST BE CHECKED REGULARLY FOR SIGNS OF DAMAGE,
AND MUST BE REPLACED IMMEDIATELY IF DAMAGED.