EN - 23
7.3 Pump Filter
1
3
5
2
4
6
The
pump
filter
system
in
your
Washing
Machine
prolongs
the
life
of
the
pump
by
preventing
lint
from
entering
your
machine.
We recommend that you clean the pump
filter
every
2
months.
The
pump
filter
is
located
behind
the
cover
on
the
front-lower
right
corner.
To
clean
the
pump
filter:
1.
You
may
use
the
washing
powder
spade
(*)
supplied
with
your
machine
or
liquid
detergent
level
plate
to
open
the pump cover.
2.
Lodge the end of the powder spade
or
liquid
detergent
level
plate
in
the
opening
of
the
cover
and
gently
press
backwards.
The
cover
will
open.
• Before
opening
the
filter
cover,
place
a
container
under
the
filter
cover
to
collect
any
water
left
in
the
machine.
• Loosen
the
filter
by
turning
anticlockwise
and
remove
by
pulling.
Wait
for
the
water
to
drain.
NOTE:
Depending
on
the
amount
of
water
inside
the
machine,
you
may
have
to
empty
the
water
collection
container
a
few
times.
3.
Remove
any
foreign
materials
from
the
filter
with
a
soft
brush.
4.
After
cleaning,
re-fit
the
filter
by
inserting
it
and
turning
clockwise.
5.
When
closing
the
pump
cover,
ensure
that
the
mountings
inside
the
cover
meet
the
holes
on
the
front
panel
side.
6.
Close
the
filter
cover.
WARNING:
The
water
in
the
pump
may
be
hot,
wait
until
it
has
cooled
down
before
carrying
out
any
cleaning
or
maintenance.
(*)
Specifications
may
vary
depending
on
the
machine
purchased.
7.4 Detergent Drawer
The
use
of
detergent
may
cause
residual
build
up
in
the
detergent
drawer
over
time.
We
recommend
that
you
remove
the drawer every 2 months to clean the
accumulated
residue.
To remove the detergent drawer:
• Pull
the
drawer
forwards
until
it
is
fully
extended.
• Press the region shown below inside
the detergent drawer you have pulled
all the way back, and continue pulling
and remove the detergent drawer from
its place
• Remove the detergent drawer and
disassemble the flush stopper. Clean
thoroughly to completely remove
