2
Fan Head Assembly
1.
There are two knobs at the Connector; the smaller one is the Tilt Knob and the bigger one is the
Locking Knob. Unscrew the Locking Knob to loosen the Thread Bolt.
2.
Pull Telescopic Inner up to your desired height and lock in place by tightening the Height
Adjustment Screw
3.
Place the Motor onto the Telescopic Inner. Align the holes on the Connector and the Telescopic
Inner. Install the Motor to the Telescopic Inner by tightening back to Thread Bolt with the Locking
Knob.
Final Assembly
1.
Position the Rear Grill over the Motor Shaft, making certain the 2 notches at the Rear Grill fit
over the 2 prongs on the Motor Housing .Make sure the Rear Grill fits securely against the Motor
Housing.
2.
Secure the Rear Grill to the Motor Housing with the four Rear Grill Locking Screws. Loosen the
grill locking screw at the bottom of the Rear Grill and save it.
3.
Install the Fan Blade onto the Motor Shaft by tightening the Blade screw to the Motor Shaft.
4.
Centre the Front Grill by aligning the logo on the grill Hub so it is horizontal and parallel to the
floor. Then secure the Front and Rear Grills completely together by snapping grill clips into place.
Lastly, tighten the grill locking screw at the bottom of the Rear Grill.
6. Place the Control box on the holes of the Telescopic Inner, then fix it with the Control Box Screw.
