Installation
1. put the cylinder into the gas heater
2. install the protection baffle to make sure the cylinder cant' move
3. connect the pipe to the gas valve with cap (make sure no leakage)
4. connect another side of the pipe to the regulator with cap (make sure no leakage)
5. open the gas tap before using the heater, and close the gas tap after using.
Lighting heater:
Before connecting the regulator to the gas cylinder. Cheek whether there is a
rubber washer on the regulator, and the washer must be in good condition.
Connect the regulator to the gas cylinder by turning the hand wheel anticlockwise.
Open the gas cylinder by turning the gas cylinder valve anticlockwise. Turn the
gas control knob on the heater to setting 1(fig 4).
Press the control knob down and hold in the pressed condition. This will allow
gas to flow to the pilot and center burner.
While holding the control knob in the pressed position push the piezoelectric
ignition (fig 4) button 2 or 3 tines. Each tine you strike this piezoelectric ignition
you will hear a clicking sound as well as see a spark on the pilot burner.
Once the pilot has lit, continue holding the gas control knob in the pressed
position for a further 10 to 15 seconds thus activating the flame failure safety
device.
The pilot and center burner should remain alight.
You may now adjust the heater setting to Low/Med/High as required.
