United Surface Solutions | 11901 Burke St, Santa Fe Springs, CA 90670 | [email protected] | (877) 837-4623
Page | 12
3.4 Manual Operation
3.4.1 Setting Manual Process Parameters
After selecting MANUAL OPERATION from the Main Menu, the
Manual Operation screen will appear. To jog the turret, hold the
Jog
button on the machine’s left side and press JOG FWD or JOG REV on
the Manual Operation screen. Set the RPM by pressing the RPM field
and entering a value, then press ENT. Set the Cycle Time by pressing
the Cycle Time field and entering a value, then press ENT. Press
R
to
reset Cycle Time Remaining if needed. Choose FWD or REV to specify
the direction the turret will spin or press AUTO REV. to split the process between forward and reverse.
To start the cycle, close the door and press PRESS TO START.
3.4.2 Running a Manual Process
Loading Cradles
To open a lid, rotate athe lockbar then pull away from the lid. The lock bar should drop towards the
center shaft of the turret. Repeat with opposite side. Then remove the lid risnse and store it in the
holding bin. Remove the Urethane liner from the cradle by carefully lifting it from the cradle and away
from the machine. Don’t wory if any foam, water or media spill into the machine, simply use the water
hose provided to rinsce it of. The shroud will capture all the water and push it our of the machine into
a bin. If you have purchase additional linner, now you are able to replace the removed liner with a new
one by reversing the process.
Making sure that the lock Bar is securely in positing and the safety
pin is locked in place.
Repeat the process with all four barrels.
To jog the turret, press CONTINUE. Hold the
Jog
button and press JOG FWD or JOG REV on the
Automatic Operation screen.
Beginning Process
To set process parameters, refer to
3.4.1 Setting Process Parameters
. To start the cycle, press PRESS
TO START.
Stopping a Process
To stop a process before it has been completed, press STOP (takes the place of PRESS TO START). The
turret will slow to a stop. Once stopped, the door will unlock and may be opened. The cycle time
remaining will be saved on the Manual Operation screen. The process can be continued by pressing
PRESS TO START. If you are done, remove your parts and reset the cycle time.
