MOUNTING THE HOUSING ON TILT TABLE
1. Center (balance) the camera/lens, or
enclosure/camera/lens load on the tilt table. Adjust the
positioning as needed to align the mounting holes.
2. Make all necessary electrical connections. Be sure to
leave an adequate loop of cables between the enclosure
and the pan/tilt, and the enclosure and the rigid mount to
prevent binding and/or strain on the cables. Refer to the
Electrical Installation and Cable connections and sealing
fitting sections.
TERMINAL ASSIGNMENT
THERMAL CAMERA TERMIANAL BLOCK
Figure 4. Terminal-Assignment Dimension for Day Camera
1. SPARE
2. SPARE
3. SPARE
4. SPARE
4. RS-232(GND)
5. RS-232(RX)
6. RS-232(TX)
7. NC
8. POWER DC24V(+)
9. POWER DC24V(-)
01 02 03 04 05 06 07 08 09 10
11 12 13 14 15 16 17 18 19 20
NOTES: 1. Terminal shown from wiring side. 2. All pins are not used.
Figure 2. Tilt Table Dimensions (Unit : mm)
01. ZOOM MOTOR +
02. ZOOM MOTOR –
03. FOCUS MOTOR +
04. FOCUS MOTOR –
05. POWER (5V)
06. POWER RETURN – (GND)
07. ZOOM OUT POSITION
08. FOCUS OUT POSITION
09. POWER DC 12V (+)
10. POWER DC 12V (-)
21. WIPER 24VDC (+)
22. WIPER GND
23. WIPER CONT POWER (+)
24. NC
25. RS-485 (RX+)
26. RS-485 (RX-)
27. HEATER AC220V
28. HEATER AC220V
29. DC24V (+)
30. GND
01 02 03 04 05 06 07 08 09 10
11 12 13 14 15 16 17 18 19 20
21 22 23 24 25 26 27 28 29 30
31 32 33 34 35 36 37 38 39 40
DAY CAMERA TERMIANAL BLOCK
Figure 3. Terminal-Assignment Dimension for Day Camera
