Installation
6
Insert the power screw terminal connector into the VAV Zone Controller's power terminals.
7
Verify communication with the network by viewing a module status report.
Wiring sensors to inputs
You can wire the following sensors to the VAV Zone Controller's inputs:
•
Space temperature sensor
•
Alternate space temperature sensor
(page 18)
•
Supply Air Temperature sensor
(page 18)
•
CO
2
sensor
(page 19)
•
Relative Humidity sensor
(page 21)
•
Remote occupancy contact sensor
(page 22)
NOTE
This document gives instructions for wiring the sensors to the VAV Zone Controller. For mounting and wiring
the sensors, see the
Carrier Sensors Installation Guide
.
Disconnect electrical power to the VAV Zone Controller before wiring it. Failure to follow this warning could
cause electrical shock, personal injury, or damage to the controller.
•
Do not run sensor or relay wires in the same conduit or raceway with Class 1 AC or DC service wiring.
•
Do not abrade, cut, or nick the outer jacket of the cable.
•
Do not pull or draw cable with a force that may harm the physical or electrical properties.
•
Avoid splices in any control wiring.
VAV Zone Controllers
15
