-4-
Warning: Explosion Hazard
•
Never use chemicals, gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar
flammable liquids to start or “freshen-up ” a fire in any heating appliance.
•
Keep all flammable liquids, especially gasoline, out of the vicinity of any heating appliance — whether in
use or in storage.
Operating Safety Precautions
1.
Never build extremely large fires in your stove as damage to the appliance or smoke leakage may result .
2. WARNING: Miracle Heat and heating appliances are HOT while in operation . Keep children, clothing, and
Furniture away. Contact may cause skin burns. Do not touch the heat reclaimer or appliance after firing
until it has cooled.
3. Inspect stove pipe and heat exchanger tubes every 60 days. Replace immediately if stove pipe or tubes
are rusting or leaking smoke into the room.
CAUTION: HOUSE FIRE HAZARDS
• Floor protector must extend underneath Miracle Heat.
•
Overfiring may cause a house fire, you are overfiring. If the heater, chimney connector, or Miracle Heat
glows red. Overfiring may damage the tubing air seals in the heat reclaimer and cause unsafe operating
conditions.
Operating Instructions
NOTICE: Before first use , review the safety precautions and installation instructions to ensure that all of the
procedures and steps have been properly completed.
Build a small fire in your stove and gradually build up to normal operating condition. Some smoke and odor may
be evident during initial operation. This will cease as the paint bakes and cures.
The Miracle Heat is designed to be automatic and will turn on when the flue pipe reaches the factory set
temperature. It will also turn off automatically when the flue temperature falls below the factory set temperature.
A toggle switch on the rear of the Miracle Heat allows the fan to operate before the thermostat activates. Do
not attempt to alter the thermostat in any way. This not only a convenience feature, but an important safety
device as well. Keep the electrical cord plugged into a live circuit at all times except during servicing to prevent
overheating and possible damage and/or malfunctioning of the unit. Do not connect this unit to a switched
circuit.
WARNING: Slow burning fires and extended use may cause excessive creosote buildup . Ignition of creosote
buildup or overfiring may cause a chimney fire . Chimney fires burn extremely hot and may ignite surrounding
materials . In case of a chimney fire call the fire department immediately .
CAUTION: Soot scraper knob and connecting rod are hot during operation and could cause severe burns . Use
protective equipment when operating or wait until unit has cooled before operating .
After each firing, operate the soot scraper (pull knob in and out) to clean the heat exchanger tubes.
Keep soot scraper knob pulled out at least 5 inches from the face of the unit while in operation.
