- 4 -
Switching the appliance into the Fwd mode:
• Place the switch
1
for continuous shredding at
the position "Fwd" (forward). The appliance runs
continuously. Insert paper from above and in
portrait format into the cutter opening
2
.
Switching the appliance into the Auto mode:
• Place the switch
1
for shredding into the position
"Auto". The motor starts automatically and switches
itself off automatically if no further paper is in-
serted.
Take note:
Always insert small papers into the
cutter opening
2
approx. 2 cm left of the middle.
That is where the contact is located to start the
shredding process.
Clearing a material blockage:
• Slide the switch
1
into the position "Rev" should
the paper to be shredded jam.
The appliance now goes into reverse and the
paper to be shredded is returned.
• Pull the paper to be shredded out of the appliance
and then place the switch
1
at "Auto".
• The appliance is now once again ready for ope-
ration.
Switching the appliance off:
• When you no longer need the appliance, always
remove the plug from the mains power socket.
Notice regarding overheating of the appliance:
If it overheats, the appliance switches off automati-
cally.
Warning:
Remove the plug from the mains power socket to
avoid an unintended starting of the appliance.
• Empty the container.
• Allow the appliance to cool down.
• Re-insert the plug into the mains power socket.
• Switch the appliance on, in that the switch
1
is
placed into the position "Auto".
Cleaning
Danger!
Always remove the power plug before cleaning the
appliance. There is a risk of receiving an electric
shock!
Warning!
The cutters in the appliance are very sharp! Injury
hazard!
• Remove possible residues in the cutter opening
2
with a suitable object. Ensure that the appliance
is unplugged before commencing this!
• Clean the appliance with a lightly moistened
cloth. For stubborn soiling use a mild detergent
on the cloth.
Non-functionality
If the material to be shredded jams:
This means that you have inserted too much paper
into the appliance (max. 5 Sheets 80g/m
2
).
• Slide the switch
1
into the position "Rev" should
the paper to be shredded jam. The appliance
now goes into reverse and the material to be
shredded is returned.
• Pull the paper to be shredded out of the appliance
and then place the switch
1
at "Auto".
• The appliance is now once again ready for
operation.
If the appliance suddenly ceases operation:
This means that the appliance is overheated and
the automatic safety cut-out has activated itself.
IB_KH4408_37688_LB4 27.08.2009 16:39 Uhr Seite 4
