DNx-SL-514 Synchronous Serial Interface Board
Chapter 1
12
Introduction
May 2018
www.ueidaq.com
508.921.4600
© Copyright 2018
United Electronic Industries, Inc.
1.8
Wiring &
Connectors
(pinout)
below illustrates the pinout of the SL-514.
Each of the four channels on the SL-514 can be configured as a master SSI port
and/or as a slave SSI port.
The SL-514 board uses a 37-pin D-sub connector.
Figure 1-6 Pinout Diagram of the SL-514 Board
All signals are referenced relative to isolated ground (iGND).
NOTE:
If you are using a accessory panel with the SL-514, please refer to the
Appendix for a description of the panel.
M_ 1
M_ 2
S_D 3
S 4
GND(0) 5
M_ 10
M_ 11
S_D 12
S 13
GND(2) 14
M_ 15
M_ 16
S_D 17
S 18
Rsvd 19
20 M_CLKOUT0-
21 M_DATAIN0-
22 S_DATAOUT0-
23 S_CLKIN0-
24 GND(1)
25 M_CLKOUT1-
26 M_DATAIN1-
27 S_DATAOUT1-
28 S_CLKIN1-
29 M_CLKOUT2-
30 M_DATAIN2-
31 S_DATAOUT2-
32 S_CLKIN2-
33 GND(3)
34 M_CLKOUT3-
35 M_DATAIN3-
36 S_DATAOUT3-
37 S_CLKIN3-
M_ 6
M_ 7
S_D 8
S 9