CHARGING THE BATTERY
READING RFID TAGS
1. Flip open the micro USB port on the reader.
Reading distance may be impacted by the type of tag and
environmental conditions. Above is based on Alien 964X
Higgs-3 tag and tested in an office environment (25˚C)
Below figures show the optimal orientation of reader and RFID
Tag for reading.
Reading Distance ( > 100cm)
Reading Distance (60
~
80cm)
30˚
90˚
3. Please fully charge the reader for 4 hours (or until
the red LED indicator turns off) before use.
2. Plug the micro USB connector into the port on the
reader and USB A connector into a USB port on
the host PC or power adapter.
-
5
-
-
6
-
BEEPER INDICATION
LED INDICATION
Single long beep Power up
Single beep
Good read
Two beeps
i. Wireless connection
ii. The reader successfully enters or
exits configuration mode
Four beeps
(Hi-Lo-Hi-Lo)
Out of range/Poor connection
Five beeps
Low power
Three beeps
Wireless disconnection
Three short beeps The reader reads a tag while
disconnected.
Off
Flashing Blue
Green for 2 sec
Flashing Red
Solid Red
Standby or Power off
Disconnected or Discoverable
Good Read
Low power
Charging
RFID Tag
RFID Tag
