background image

FCC WARNING STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference 
to radio communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one of the following 
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

CANADIAN DOC STATEMENT

This digital apparatus does not exceed the Class B limits for radio noise for digital 
apparatus set out in the Radio Interference Regulations of the Canadian Department of 
Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les 
limites applicables aux appareils numériques de las classe B prescrites dans le 
Réglement sur le brouillage radioélectrique édicté par les ministère des Communica-
tions du Canada.

CE MARKING AND EUROPEAN UNION COMPLIANCE 

Testing for compliance to CE requirements was performed by an independent 
laboratory. The unit under test was found compliant with all the applicable Directives, 
2014/30/EU, 2014/35/EU and 2014/53/EU.

WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT

The WEEE directive places an obligation on all EU-based manufacturers and
importers to take-back electronic products at the end of their useful life. 

ROHS STATEMENT OF COMPLIANCE

This product is compliant to Directive 2002/95/EC.

NON-MODIFICATION STATEMENT

Changes or modifications not expressly approved by the party responsible for 
compliance could void the user's authority to operate the equipment. 

RoHS

1

 -

1. Take any metals into contact with the terminals in connectors.
2. Use the scanner where any inflammable gases.

If following condition occur, immediately power off the host computer, 
disconnect the interface cable, and contact your nearest dealer.
1. Smoke, abnormal odors or noises come from the scanner.
2. Drop the scanner so as to affect the operation or damage its housing.

Do Not

Do not do behavior below.
1. Put the scanner in places excessively high temperatures such as expose 

under direct sunlight.

2. Use the scanner in extremely humid area or drastic temperature 

changes.

3. Place the scanner in oily smoke or steam environment such as cooking 

range.

4. Be covered or wrapped up the scanner in bad-ventilated area such as 

under cloth or blanket.

5. Insert or drop foreign materials or water into scanning window or vents.
6. Using the scanner while hand is wet or damp.
7. Use the scanner with anti-slip gloves containing plasticizer and 

chemicals or organic solvents such as benzene, thinner, insecticide etc 
to clean the housing. Otherwise, it could not result fire and electrical 
shock but housing may be broken and injured.

8. Scratch or modify the scanner and bend, twist, pull or heat its interface 

cable.

9. Put heavy objects on interface cable.
Do not stare the light source from the scanning window or do not point the 

scanning window at other people’s eyes or eyesight may be damaged 
by direct exposure under the light.

Do not put the scanner on an unstable or inclined plane.
The scanner may drop, creating injuries.

Once the interface cable is damaged such as exposed or broken copper 
wires, stop using immediately and contact your dealer. Otherwise, it could 
result fire or electrical shock.

WARNING AND CAUTION

2

 -

Summary of Contents for MS650




















Reviews: