39
Milling with the machine
SKF 25
ENGLISH
Milling with the machine
For milling, proceed as follows:
Align the workpiece to be processed horizontally and secure
it.
CAUTION
Potential damage to property if the machine is improperly
used!
Observe the following instructions to avoid damage:
Lay the connecting cable so that it cannot be caught by the
►
running machine.
Mount the guide roller according to the desired application,
see section
Mounting the guide roller
.
Set the milling angle and chamfer width, see section
Setting
the milling angle
and
Setting the chamfer width
.
Insert the plug into the mains socket.
Put the machine onto the workpiece so that the miller does
not move into the workpiece.
Switch on the machine, see section
Switching on the ma-
chine
.
NOTE
Observe the following instructions:
Never attach the reversing plates to the material during
►
standstill.
Maintain an even feed.
►
Slide the machine slowly and evenly from right to left in the
direction of the arrow. The tool operates against the direction
of travel.
Switch off the machine, see section
Switching the machine
on/off
.
Pull the plug out of the mains socket.
CS Unitec, Inc.
, 22 Harbor Ave., Norwalk, CT 06850 •
Toll-free:
800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 •
Email:
Website:
www.csunitec.com
Summary of Contents for SKF 025
Page 69: ......
