PRE-OPERATING INSTRUCTIONS
Check air supply for correct pressure (90 PSI min.) and sufficient
flow (85 CFM min.). Daily, blow out air line to dislodge any
debris, moisture or foreign matter from the air line and the
compressor.
WARNING!
Use extreme caution when blowing
out pressurized air lines and or air hoses. Expelled particles can
cause severe injury. Connect water hose for wet-cutting
applications, or vacuum hose for dry-cutting applications. Connect
air supply hose to saw. Check for leaks.
OPERATING INSTRUCTIONS
Under no circumstances should this saw be operated by
personnel who have not been trained in the operation of saw
cutting.
Make sure the blade is in the raised position and not in contact with
the surface being cut. Squeeze the throttle. When the saw has
attained full speed, slowly engage it into the cut. Because the saw
cuts in a clockwise direction, it will pull itself into the cut . A
small amount of resistance should be applied when first entering
the cut.
Do not under any circumstance
force the blade into the
cut, as forcing could bend or break the blade. When finishing the
cut, slowly raise the jack until the blade is clear of the cut. Release
the trigger and let the motor come to a complete stop.
______________
Saws returned to CS Unitec for warranty consideration must be
shipped prepaid, along with proof of date of purchase, a brief
description of the problem, and a CS Unitec Return Goods
Authorization (RGA) number issued by CS Unitec’s Customer
Service Department.
- 5 -
PRE-OPERATING INSTRUCTIONS
Check air supply for correct pressure (90 PSI min.) and sufficient
flow (85 CFM min.). Daily, blow out air line to dislodge any
debris, moisture or foreign matter from the air line and the
compressor.
WARNING!
Use extreme caution when blowing
out pressurized air lines and or air hoses. Expelled particles can
cause severe injury. Connect water hose for wet-cutting
applications, or vacuum hose for dry-cutting applications. Connect
air supply hose to saw. Check for leaks.
OPERATING INSTRUCTIONS
Under no circumstances should this saw be operated by
personnel who have not been trained in the operation of saw
cutting.
Make sure the blade is in the raised position and not in contact with
the surface being cut. Squeeze the throttle. When the saw has
attained full speed, slowly engage it into the cut. Because the saw
cuts in a clockwise direction, it will pull itself into the cut . A
small amount of resistance should be applied when first entering
the cut.
Do not under any circumstance
force the blade into the
cut, as forcing could bend or break the blade. When finishing the
cut, slowly raise the jack until the blade is clear of the cut. Release
the trigger and let the motor come to a complete stop.
______________
Saws returned to CS Unitec for warranty consideration must be
shipped prepaid, along with proof of date of purchase, a brief
description of the problem, and a CS Unitec Return Goods
Authorization (RGA) number issued by CS Unitec’s Customer
Service Department.
- 5 -
