OPERATIONAL AND SAFETY INSTRUCTIONS:
BE SURE TO READ ALL INSTRUCTIONS BEFORE ASSEMBLING
AND OPERATING THIS EQUIPMENT.
* All CS Unitec pneumatic saws are designed to be operated @ 90 P.S.I.
min. (6.2 bar) air pressure, 85 CFM min., with a minimum 1/2” (13 mm)
I.D. air hose. Using higher pressure to attain more horsepower will
drastically shorten tool life.
* The Saw motor is factory pre-set at 2900 RPM. Be sure your blade will
operate at that speed.
* After every 40 hours of operation, or as experience indicates, inject 1 to
2 cc’s (2-3 pump strokes) of a quality gear grease into the saw’s zerk
fittings.
W A R N I N G S ! !
* Always turn off the air supply and disconnect the air supply hose before
installing, removing, or adjusting any accessory on this tool — especially
the cutting blade — or before performing any maintenance on this tool.
Failure to do so could result in serious injury or death!
* P
neumatic tools can vibrate during use. Repetitive motions,
uncomfortable positions and vibrations can cause injury to hands, fingers,
or wrists.
STOP
using any tool if discomfort, a tingling feeling, or pain
occurs. Seek your supervisor’s advice before resuming use.
* Projectile Hazard
- Always wear safety glasses to prevent eye injury
or loss of sight when operating power tools.
The most important safety
device for this tool or any power tool is YOU!
Your care and good
judgment are the best protection against injury.
* Hearing loss can result from prolonged exposure to excessive sound
levels.
ALWAYS
use approved hearing protection.
* Dust mask should be worn when using this saw in dry-cutting
applications.
* Wear safety shoes during equipment use. DO NOT wear loose clothing
which could get caught in equipment.
- 2 -
OPERATIONAL AND SAFETY INSTRUCTIONS:
BE SURE TO READ ALL INSTRUCTIONS BEFORE ASSEMBLING
AND OPERATING THIS EQUIPMENT.
* All CS Unitec pneumatic saws are designed to be operated @ 90 P.S.I.
min. (6.2 bar) air pressure, 85 CFM min., with a minimum 1/2” (13 mm)
I.D. air hose. Using higher pressure to attain more horsepower will
drastically shorten tool life.
* The Saw motor is factory pre-set at 2900 RPM. Be sure your blade will
operate at that speed.
* After every 40 hours of operation, or as experience indicates, inject 1 to
2 cc’s (2-3 pump strokes) of a quality gear grease into the saw’s zerk
fittings.
W A R N I N G S ! !
* Always turn off the air supply and disconnect the air supply hose before
installing, removing, or adjusting any accessory on this tool — especially
the cutting blade — or before performing any maintenance on this tool.
Failure to do so could result in serious injury or death!
* P
neumatic tools can vibrate during use. Repetitive motions,
uncomfortable positions and vibrations can cause injury to hands, fingers,
or wrists.
STOP
using any tool if discomfort, a tingling feeling, or pain
occurs. Seek your supervisor’s advice before resuming use.
* Projectile Hazard
- Always wear safety glasses to prevent eye injury
or loss of sight when operating power tools.
The most important safety
device for this tool or any power tool is YOU!
Your care and good
judgment are the best protection against injury.
* Hearing loss can result from prolonged exposure to excessive sound
levels.
ALWAYS
use approved hearing protection.
* Dust mask should be worn when using this saw in dry-cutting
applications.
* Wear safety shoes during equipment use. DO NOT wear loose clothing
which could get caught in equipment.
- 2 -
