Unit USI-284, Instruction Manual

Page: 4 / 10

Spray
1. The spray can be used in any position, either in dry or steam ironing, as long as the water tank is filled with
water.
2. Press the spray button for this function.
NOTE: This button has to be pressed repetitively to start this function for the first time.
Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1. Place the temperature selector at the “max” position and wait until the pilot light goes out (Pic 3).
2. Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE: For the best steam quality, do not use more than three successive bursts each time. Several pumping
actions are needed to start this function.
Excessive use of this feature will cause the iron to cool, ensure that the pilot light is out, before operating
the shot of steam control
Cleaning and maintenance.
After use.
1. Disconnect power supply and empty the water left in water tank.
2. Wait for the sole completely cool before you remove the iron.
3. Wipe the iron soft, damp cloth. Do not use solvents to clean the soleplate and abrasive cleaners.
4. Store the iron in an upright position. Avoid scratching the sole.
Self-clean function.
It is necessary to regularly clean the iron, depending on the water hardness and intensity of use.
1. Fill water into the water tank and set the temperature selector to Max position
2.
Connect the iron to the network. Make sure the steam regulator is set to “Off”.
Warning: Never pour vinegar or other liquid cleaners for eliminating calcium into water tank!
3. As soon as the iron heats up, and the light indicator goes out, hold the iron over the sink, press and hold self-
cleaning (11). The steam and boiling water will come out through the holes in the sole of washing away scale
and impurities.
4. Release the button self-cleaning as soon as the water in the tank is over.
Auto-decalcification function
Iron equipped system Auto-decalcification (Anti-Calc). Thanks to it, reduces the rate of scale formation.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during manufacture need to be burnt off allow ten
minutes for odor to disappear.
Iron does not heat
The iron should be plugged into 220-240 V, AC electrical outlet only. The temperature dial must be set at the desired
temperature.
Iron does not steam
The water tank many be empty. Turn the steam valve to “
” and add water. Allow the iron to heat, and then set the
steam dial to the steam setting.