6
POWER REQUIREMENTS
The Unique UGP-80L1 W portable fridge/freezers are designed to
operate on AC and DC voltage inputs.
AC input
Voltage is required to be 110V AC at 50 - 60 Hz
DC input
Voltage is required to be 12 or 24 DC +/- 10%
AC/DC Convertor is 12V
AC POWER CONNECTION
The Unique UGP-80L1 W portable fridge/freezers are supplied with
an approved 2 pin AC power cord. It is recommended that this cord
is not lengthened as this may result in a voltage drop and reduced
performance.
DC POWER CONNECTION
EMERGENCY OVERIDE
The Unique UGP-80L1 W portable fridge/freezers are supplied with
a vehicle DC plug (cigarette lighter plug). It is recommended that
this cord is not lengthened as this may result in a voltage drop and
reduced performance.
When connecting the fridge/freezer to DC, plug the power cord into
the DC socket on the fridge/freezer and then plug the other end of
the power cord into the DC supply.
The supplied DC power cord comes with an in-line fuse. If the red
indicator light on the DC cigarette plug is not illuminated, there is
either no DC voltage being supplied or the
fuse is blown
. See below
for fuse replacement instructions.
*
Only use the DC power cord that is supplied with the fridge/freezer.
The emergency switch is located above the power inlet socket on
the side of the unit. If the digital thermostat fails and you are un-
able to set the temperature, turn this switch to Emergency override.
This enables the fridge to run until you reach a service centre to
replace the faulty component.
NOTE:
If the switch is in the “ EMERGENCY OVERRIDE” position,
the fridge/compressor will run with full cooling capacity and may
freeze. This will only freeze the zone of the fridge that is currently
turned on before flicking the emergency override switch.
