7
INSTALLATION
UNPACKING AND CLEANING
Remove all packaging and securing tapes from the appliance.
To avoid injury and causing damage to the appliance, be extremely
cautious when using sharp or pointed tools to complete this task.
Keep children away from the packaging material - DANGER OF SUF-
FOCATION! Wash the inside and outside of the appliance with luke
warm water and a mild soap or detergent. Abrasive or corrosive
cleaning agents, steel wool, scouring sponges, or chemical cleaning
agents
should not
be used under any circumstances. A sponge, soft
brush or towel is recommended. After cleaning, thoroughly rinse and
dry. You may want to leave the lid open allowing the compartment
to ventilate for 20-30 minutes to get rid of residual odors. Check with
your local Environmental Agency for recommendations on recycling
packaging materials in your area.
POSITIONING THE APPLIANCE
The area in which the fridge/freezer is to be installed must be rela-
tively cool, dry, and suitably ventilated. The area must be protected
against any inclement weather (rain, snow) and excessive surface
dust. To ensure proper function, the appliance must be placed
horizontally on a flat, firm, and stable surface resting level on all four
supports. The floor must be strong enough to support a fully loaded
cabinet. Use wood or metal shims to level the fridge/freezer if neces-
sary.
Do not place the fridge/freezer close to heat sources (heater, stove,
boiler, chimney, etc.), and avoid prolonged exposure to direct sun-
light. This appliance uses the exterior walls to transfer heat from
the inside of the cabinet. Ensure that there is adequate space be-
tween the fridge/freezer and neighboring walls or large objects. A
minimum spacing of 3 inches (7.5 cm) is highly recommended. This
will provide sufficient airflow around the appliance resulting in more
efficient operation and longer appliance lifetime. Always keep the air
vent openings of the compressor housing cover free from dust and
obstructions.
