Unique UGP-30RH PL1, Owner'S Manual

Page: 9 / 23

9
INSTALLATION
If possible, unplug the stove and move it in order to have better ac-
cess to the rear wall. Otherwise, place a thick blanket on the counter
and the cooking surface to protect it from damage and dirt. Select a
flat surface for assembling the device.
Then put the debris of the cover and hardware on to the protective
cap.
Determine and mark the center line on the wall where you installed
the canopy hood.
Determine a comfortable height for the user and mark it on the wall
behind the stove top.
Place the template on the center line and the bottom of the hood
with adhesive tape.
Place the squares of the flue
The flue must be installed against the back wall and the ceiling.
This bracket will keep the chimney up to the top.
Attach the brackets to the wall:
• Align the center lines drawn on the bracket with the center lines on
the wall.
• Identify the two screw holes on the wall.
• Drill pilot holes 5/16 “in the locations shown.
• Place the fastening clips to the wall.
• Tighten wood screws, by hand, in the attachments to allow hooks
to expand. Remove the screws.
•Drill guide hole, 5/16inch.
•Make clamp fix to the wall, screw down the bolts on the wall.
• Attach the bracket to the wall using the screws and / or fasteners.
Ceiling pipe
If the duct vents just above the ceiling:
• Use a level to draw a line, the center line of the template to the
ceiling.
• Measure at least 4 “from the back wall to the center of the circle
with a hole 7 - ½” in the ceiling.