5
DISPOSING OF THE APPLIANCE
• When disposing of your freezer, use an authorized disposal site. The refrigerant must be
completely drained and collected by an authorized technician for recycling prior to disposal.
Check with your local Environmental Agency for recommendations on recycling this appliance
in your area. Remove the electrical connection wiring and also ensure that the lid is removed to
prevent children from being trapped inside
- DANGER OF SUFFOCATION!
This marking indicates that this product should not be disposed with other household
wastes throughout North America. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources.
IMPORTANT:
After transit where the fridge
has been on its side or back, ensure that the fridge is in a level, upright position for
12 hours before connecting the appliance to a power source, this will reduce the
possibility of a malfunction in the cooling system from handling during transportation.
INSTALLATION INSTRUCTIONS
UNPACKING AND CLEANING
Remove all packaging and securing tapes from the appliance. To avoid injury and causing damage
to the appliance, be extremely cautious when using sharp or pointed tools to complete this task.
Keep children away from the packaging material
- DANGER OF SUFFOCATION!.
Wash the inside
and outside of the appliance with lukewarm water and a mild soap or detergent. Abrasive or
corrosive cleaning agents, steel wool, scouring sponges, or chemical cleaning agents should not
be used under any circumstances. A sponge, soft brush or towel is recommended. After cleaning,
thoroughly rinse and dry. You may want to leave the doors open allowing the compartments
to ventilate for 20-30 minutes to get rid of residual odors. Check with your local Environmental
Agency for recommendations on recycling packaging materials in your area.
POSITIONING THE APPLIANCE
The area in which the fridge is to be installed must be relatively cool, dry, and suitably ventilated.
The area must be protected against any inclement weather (rain, snow) and excessive surface
dust. To ensure proper function, the appliance must be placed on a flat, firm, and stable surface
resting level on all four supports. The floor must be strong enough to support a fully loaded
cabinet. Use wood or metal shims to level the fridge if necessary. Do not place the appliance in
direct sunlight or near sources of heat, such as a stove or heater, as this can increase electrical
consumption. Extreme cold ambient temperatures may also cause the appliance to perform
improperly.
Do not place the fridge close to heat sources (heater, stove, boiler, chimney, etc.), and avoid
prolonged exposure to direct sunlight. This appliance uses the exterior walls to transfer heat from
the inside of the cabinet. Ensure that there is adequate space between the fridge and neighboring
walls or large objects.
A minimum spacing of 3 inches (7.6 cm) is highly recommended.
This will
provide sufficient airflow around the appliance resulting in more efficient operation and longer
appliance lifetime. Always keep the air vent openings of the compressor housing cover free from
dust and obstructions. This appliance is intended for free-standing installation only and is not
intended to be built into a cabinet or counter.
IMPORTANT SAFETY NOTES (continued)
Summary of Contents for Classic UGP-175L UR W
Page 14: ...14 PARTS DIAGRAM LIST ...
