COPYRIGHT 2016, UNIQUE AUTOMATION
- 11 -
08/11/2016 12:57
It is often easier to draw more water than needed and adjust the depth by manually
lifting the drain until the water level is at 0%
Bath tub calibration should only be undertaken when the bath tub is in sight, and
you have easy access to the power switches supplying bathomatic and all
associated equipment. It is advisable that calibration is done prior to final
positioning of the bath panels/aprons.
bathomatic can only operate reliably if it is
calibrated correctly
100% - bath calibration
Different bathtubs hold different amount of water and 100% calibration is
absolutely necessary
to ensure correct operation. bathomatic can take any depth
to be 100% and you have to set it for your own bath. This should be set at around
20mm below the point of overflow. When bathtub is at 100% depth let the water
settle for 1 minute then select SET 100% in the SERVICE MENU and press
to
store the value.
Before you attempt to SET 100% you must first SET 0%
It is strongly recommended that 100% bath calibration is made below the point of
overflow.
If 100% - bath calibration is set at the point of overflowing, due to the
fluctuation of depth reading bathomatic may never reach 100%, thus it may
not stop filling should 100% fill is requested.
Bathomatic must be
“PAUSED” for 0% or 100% bath calibration to take place
Temperature Offset
Allows the temperature reading from the bath to be offset. Must only be performed
by trained professionals or after consulting our technical stuff.
Temperature Calibration
Allows temperature sensor calibration. Must only be performed by trained
professionals or after consulting our technical stuff.
Reset
Factory reset the device to its factory settings. All customer data including presents
and calibration will be lost.
