uniQam Scout, User Manual

Page: 3 / 56

3 3
EN
Warnings
Please read the following instructions carefully to use
the product properly and protect the user’s safety.
– The waterproof housing must be checked for leaks before each use. The seal
must be lean and undamaged. Check this before each use by a dive without
the camera. We accept no liability for any damage caused by leaks in the
casing.
– Attach the camera always in a way, that it does not get lost in a possible
drop off self adhesive pad or at a breaking of other mounting parts. Secure
the camera always in addition, for example by attaching a safety line to the
camera housing. We assume no liability for direct or indirect damages caused
by the failure of hardware.
– Do not attach the camera to the outside of vehicles, if you are participating in
public traffi c, or if the camera is causing danger to others in a possible fall.
– Seals and mounting parts are aging, depending on frequency of use and
ambient conditions (for example sunlight, temperature, humidity, vibration).
Therefore this parts needs to be replaced regularly.
– Do not disassemble, repair, or alter the product. When malfunctions, error,
or other accidents are found to be attributable to a user, a user may not be
eligible for warranty service.
– In case of smoke or burning smells, unplug the power cable immediately.
– Do not spray water directly on to the device. It may cause damage, fi re or
electric shock.
– Keep the device away from chemicals or detergents as they may change the
surface of the camera and damage the device.
– Avoid excessive impact and do not insert any foreign object into the device. It
may cause damage to the device.
– When a foreign materials or sticker blocks the lens, a normal operation is
not possible. Please keep the lens clean and clear. Also, when other objects
are placed around the camera, they may be refl ected on the window and
included in the video images. Please do not leave unnecessary objects
around the device.
– Make sure the camera is installed tightly and do not move the device after
installation.
– And do not impact excessive shock to the product.
– Do not control or operate the device with wet hands. It may cause electric
shock.
– Do not operate device while driving.
– In extreme cases like when a vehicle enters or exit a tunnel with sudden
change of light, when the light is too strong or when there is no source of
light, recorded image may not be satisfactory condition.
– If the windscreen of the car is tinted; recorded image may be poorly defi ned
or distorted.
– If the power supply was disconnected by huge scale or accident; the event
may not be recorded.