7.FUNCTION AS A WEIGHT CHECKER
51
7-2-3. Under
When RESULT < FINAL SETTING - UNDER SETTING, the status display
“LO”
lights and the
output signal
“LO”
turns ON (only while the COMPLETE signal is output).
After the end of the COMPLETE signal output, the above output signal turns OFF, and the status
display is gray-backed.
(input range: 0 ~ 999)
Operation
7-2-4. Accumulation clear
The values and counts accumulated by code are cleared.
Operation
7-2-5. Total comparison/ Total limit/ Count limit
It can compare with Accumulation value or Count limit of each code.
Moreover, it can select external output ON or OFF of the result of comparison.
Setting for each code is also possible.
1) TOTAL COMP MODE
It is the selection whether compares with Accumulation value or not.
Select from COMP. OFF, Total COMP. ON, Total COMP. OFF, Count
COMP. ON, or Count COMP. OFF.
The Total comparison is conducted then
changes to
on
the comparison screen and message screen when Total limit output is ON.
COMP OFF
Comparison is not conducted. Pin49 becomes "RUN" signal.
TOTAL COMP ON
When Accumulation value
≧
Total limit setting value, it is considered
as "Total limit".
External output is conducted. Pin49 becomes "Total limit" signal.
TOTAL COMP OFF
When Accumulation value
≧
Total limit setting value, it is considered
as "Total limit".
External output is not conducted. Pin49 becomes "RUN" signal.
COUNT COMP ON
When Accumulation counts
≧
Count limit setting value, it is
considered as "Total limit".
External output is conducted. Pin49 becomes "Total limit" signal.
COUNT COMP OFF
When Accumulation counts
≧
Count limit setting value, is considered
as "Total limit".
External output is not conducted. Pin49 becomes "RUN" signal.
MODE
EACH CODE
UNDER
→
→
Press
→
Input 0 ~ 999
OK
→
(Code No.)
→
MODE
EACH CODE
(Code No.)
→
→
Press
ACCUM. CLEAR
→
→
Select NO/ YES
OK
→
RUN
ACCUM.
