Unipulse F805AT-BC, Operation Manual

Page: 81 / 202

6.SETTING AND ADJUSTMENT OF READING
66
6-5-7. Disp. data select 1
Use this menu item to select data to be displayed in the upper part of comparison
screen. Selecting “EXTERNAL ENTRY” in this menu enable an external signal to
select data. (3-5 pins of external I/O connector).
Operation
6-5-8. Disp. data select 2
Use this menu item to select data to be displayed in the lower part of comparison
screen. Selecting “EXTERNAL ENTRY” in this menu enable an external signal to
select data. (6-8 pins of external I/O connector).
Operation
Options: BELT SPEED, WEIGHT DENSITY, FEED RATE, LOAD RATIO,
FEED RATIO, GROSS WEIGHT, CONTROL RATE *1,
*1 Bar graph end point is fixed to 100.0%
*2 Bar graph end point is fixed to 100.0%.
The bar graph represents absolute value.
MODE GRAPH SETTING
→ →
DISP DATA SELECT 1
CTRL. DEVIATION *2, EXTERNAL ENTRY
Options: BELT SPEED, WEIGHT DENSITY, FEED RATE, LOAD RATIO,
FEED RATIO, GROSS WEIGHT, CONTROL RATE *1,
*1 Bar graph end point is fixed to 100.0%
*2 Bar graph end point is fixed to 100.0%.
The bar graph represents absolute value.
MODE GRAPH SETTING
→ →
DISP DATA SELECT 2
CTRL. DEVIATION *2, EXTERNAL ENTRY