Unipulse F701+, Operation Manual

Page: 42 / 149

35
4 Performing Final Discharge Control
35
Pe
rf
or
m
in
g
Fi
na
l D
is
ch
ar
ge
Chapter
4
4-8-3. At start NZ confirmation
This setting is used to check whether or not near
zero signal is ON when starting weighing.
Weighing starts normally if near zero is ON;
Seq. error 4 is displayed if OFF.
Refer to P.31 "4-7-1.Near zero comparison
mode" for near zero settings.
4-8-4.
At start weight value confirmation
This setting is used to check whether or not the
weighing value has reached the point of set
point 1 (final - set point 1) when starting
weighing. (Select from 0: Off/1: On.)
Sequence 5 is displayed when the weighing
value reaches the setting value of set point 1.
4-8-5. Adjust feeding/compensation feeding time
Set whether or not to perform adjust feeding
after weighing complete. When ON is selected,
set the time to perform adjust feeding after
weighing complete.
4-8-6. Number of times for knocking/knocking time
Set the duration for which and number of times
that the knocking output repeatedly turns ON
and OFF after SP3 is turned ON.
What is knocking?
In order to shake off residue inside a tank, a
fixed number of times and duration for the pulse
can be output from the external signal (output selection) of F701+.
[Sequence mode] (Setting mode 2-4)
1: At start NZ confirmation ON
0: At start NZ confirmation OFF
Sequence control
[Sequence mode] (Setting mode 2-4)
1: At start weight value
confirmation ON
0: At start weight value
confirmation OFF
Sequence control
[Sequence mode] (Setting mode 2-4)
1: Adjust feeding ON
0: Adjust feeding OFF
Adjust feeding
[Compensation feeding time] (Setting mode 1-4)
(Input range: 0.00 to 9.99)
[Number of times for knocking]
(Input range: 00 to 99)
[Knocking time] (Setting mode 5-7)
(Input range: 0.00 to 9.99)
(Setting mode 5-6)
Hopper
F701+
Residue