Unipulse F350, Operation Manual

Page: 79 / 115

66
9 OPTION INTERFACE
66
OPT
ION INT
E
RFA
C
E
Chapter
9
■
Output data select
《
Setting value
》
0
：
Calculated value The calculated value is output.
1
：
ch1 value The ch1 value is output.
2
：
ch2 value The ch2 value is output.
3
：
External select Data selected by the data select input (A15, B15) is output.
* In the case of external selection, read after at least 2 cycles.
◇
Output data select setting method
1.
Select setting mode 5.
Press
→
four times.
2.
Set "Output data select."
Press once. ⇒ "Output data select" is displayed.
Press once, and present set value blinks.
Input the setting value with .
（
Initial value:0
）
Press to validate it.
3.
Press twice to go back to the indicated value display.
■
Signal timing
●
Minus Turns on when the output indicated value data is negative.
●
OVER Turns on at over-scale time.
-LOAD
、
+LOAD
、
OFL1
、
OFL2
●
STAB Turns on at stable-time. See "5-7. Motion Detect" on page 41.
●
STROBE Strobe pulses are output in synchronization with BCD data.
For reading the data, use the rising edges of the pulses when the
logic is negative, and the falling edges of the pulses when the logic
is positive.
Data select 1 Data select 0 Output data
OFF OFF
Calculated value
(hold synchronized)
OFF ON ch1 value
ON OFF ch2 value
ON ON
Calculated value
(hold not synchronized)
Ch 2
H I LO
Ch1
H I LO
FNC
H I
Ch1 Ch 2
OK LO PEAK HOLD
H I LO H I LO
ESC