6.MEASUREMENT
・
HOLD FUNCTIONS
20
6-2-4. Application of the Hold Clear Function
If the hold clear is turned ON when the hold request is ON (in the detection section), the previous
hold value is once cleared, and then hold detection proceeds.
< About average value measurement time >
What can be specified as a section for average value hold detection is up to 10
seconds (average count: 30000). Even if the hold request bit is ON exceeding
that time, the average value in 10 seconds is held.
Point
< About the request bit delay times (t1 to t3) >
Since the delay times change depending on the system environment, sufficient
evaluation should be performed before use in response to the actual status of use.
Attention
Hold request
Peak
Detection
OFF
ON
OFF
ON
Peak
Measurement
value
Hold value
clear request
