Hi-Hat Assembly:
Expand tri-pod legs to balance stand on floor, insert floor pedal support brace into stand base and tighten down wing nut. Install
19.5” black shaft down into hole on top of stand and rotate clockwise to tighten into mechanism. Place one 9.5” cymbal (bell
down) on the clutch base of the stand. Install black hi-hat clutch to top 9.5” cymbal (bell up) by placing cymbal in-between two
felt washers with wing nut side of clutch facing up. Slide down onto black shaft and rest together with bottom cymbal. Depress
pedal about 1” to lower shaft & tighten wing nut on top cymbal. The hi-hat is a devise that will clang the two cymbals together
when the pedal is repeatedly depressed. Position the hi-hat assembly, as pictured, behind bass drum and to the left of the bass
drum pedal.
Cymbal & Stand Assembly:
Expand tri-pod legs to balance stand on floor, remove top wing nut and felt washer. Install 12” cymbal onto stand and replace
washer & nut. Adjust stand height and cymbal tilt angle as desired.
Position cymbal stand assembly, as pictured, to the right of
the bass drum.
Final Assembly: (install 2 tom drums to the bass drum with the pedal facing you).
Insert long side of the tom arms at a 90-degree angle into the mounting receptacles and install & aim 8” tom to the left and 10”
tom
to the right position. Arrange other components to playing position.
Floor Tom Drum Bass Drum Components Snare Drum Hi-Hat Cymbal Stand Throne
Snare Stand Hi-Hat & Cymbal Stand Cymbals
Floor Tom Hardware Heads Tom Arms Claw
Tom Drum Bass Drum Pedal
www.uniondrum.com
Mailing Address: PO Box #270655 Milwaukee, WI 53227
Distribution Center: 1512 Ellis Street Waukesha, WI 53186
SJC 8/11/2010
*
See reverse side for more information
