Page 3
For technical questions, please call 1-888-866-5797.
Item 57039
Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
WARNING! TO PREVENT SERIOUS INJURY:
Verify that installation surface(s) have no hidden
utility lines before drilling or driving fasteners.
1. Only install Safe on a stable, level, clean
and dry floor capable of supporting the
weight of Safe and its contents.
2. Remove the two steel plates from the bottom of
the Safe by laying the Safe down and removing
two steel bolts from each steel plate.
Safe Bottom
3. Locate two mounting holes on bottom of Safe.
a. Remove Safe’s interior floor liner.
b. Remove the two black caps inside the floor fire
insulation that cover the holes. Save caps.
Interior
Floor
Black
Cap
4. Using the Safe as a template, mark
locations of mounting holes on floor.
5. Secure Safe with anchors appropriate for the
mounting surface and are rated to support
the weight of the Safe and its contents.
6. Mount to floor with two Floor Anchors (included):
a. Using a masonry bit (sold separately) the same
diameter as the largest part of the floor Anchor
(14mm), drill two holes in marked locations, 1/4
″
deeper than the length of the Anchor’s sleeve.
b. Using a hammer (sold separately), gently tap
floor Anchors into holes with threads facing up.
c. Place Safe over exposed ends of the two
floor Anchors, then secure with two M10 x 70
Lag Screws and Gasket Washers (included).
Anchor
Screw
(1 of 2)
Washer
(1 of 2)
Interior
Floor
Black
Cap
7. Replace saved black caps and
Safe’s interior floor liner.
Installing the Battery
1. To access the battery, remove the Keypad cover from
the front of the Safe by turning it counterclockwise.
2. Remove Keypad Cover and hold the
battery connector while removing/installing
the battery.
Do not pull the wires.
3. Install battery and position it in proper polarity.
Do not use a swollen or leaking battery.
Battery
4. Replace Keypad Cover by screwing it back in place.
Leave door open until Entry Code is set.
Note:
When the battery needs to be replaced, a red light
will illuminate when any button is pressed on the Keypad.
Dispose of used batteries according to local regulations.
