Union Audio elara.4, Product User Manual

Page: 11 / 19

11
Master Sec on
EQ/Isolator
– The EQ/isolator with variable crossover control is
designed to complement the channel EQ and allow for some highly
crea ve sound sculpturing.
It has a fixed “Q” of 1 and can be swept
from 150Hz to 1kHz (Low - Mid crossover point) by adjus ng the “X -
over freq” control. The EQ/Isolator offers full signal cut and +6dB of
boost over three frequency bands, High, Mid, Low. Like an EQ the
Isolator can be used for audio frequency correc on, however, unlike
an EQ the Isolator completely a enuates the signal when the knobs
are fully an
- clockwise. With the knob pointers in the centre posi on
the frequency response is flat.
Master –
The Master Output level is adjusted from fully off to
+10dBu gain. For best signal to noise ra o (SNR) it is recommended
opera ng the mixer with the knob pointer at “12 o
- clock” or above. If
this results in excessive volume then reduce the gain on the
connected power amplifiers
Booth –
Adjusts the signal level of the Booth Outputs from off to
+10dBu when rotated fully clockwise. For best signal to noise ra o
(SNR), set the level with the pointer at or above the 12 o’clock
posi on.
Phones –
Adjusts the level of the headphone output. The elara.4
is fi ed with a powerful headphone amplifier, op mised for use with
headphones having an impedance between 33ohms to 170ohms.
Headphones with impedances above or below the recommended
impedance should be avoided, and in par cular headphones with
impedances below 33ohms could cause damage to the circuitry.
WARNING! Avoid opera ng the mixer with headphones at
high volume or for extended periods of me as this can
contribute to severe hearing loss!