Unimig RAZOR CUT 45, Operating Manual, Page: 9 / 12

9
RAZOR CUT 45 AIR COMPRESSOR
OPERATING MANUAL
5. Machine Setup
1. Start by installing the brackets to the bottom
of the RAZOR CUT 45. Using a philips screw
driver, loosely tighten 2 screws on each backet
into the open holes on the base of the CUT
45. (The short side of the bracket is meant
for the CUT 45, and the longer side is for the
compressor)
2. After installing both brackets on the base of the
CUT 45, carefully lower the machine onto the
compressor. Ensure the holes on the bottom
of the bracket line up to the holes on the
compressor.
3. Use the remaining 4 screws (2 per side) to mount
the CUT 45 to the compressor. Then retighten all
8 screws.
*ENSURE YOUR MACHINE IS OFF AND UNPLUGGED BEFORE STARTING ASSEMBLY PROCESS*