Cordless Framing Nailer
E&OE
© 2017 Unimac
2
Operation
Description
This
angle finish nailer drives Ga. 15 finish nails from 32mm to 64mm length. Large cast aluminum body provide
more power to easily drive nails in to hard wood. The well balance design can make you work efficient. The
angle magazine can make you shoot any corners. Features 360-degree exhaust port can be adjusted to any
direction. And quick release nose cover to easily clear jams. Angle finish nailer is ideal for door and window
trims, exterior trims, and cabinet work, finish paneling, decorative trims and etc.
Air supply
1. Use clean, Dry and Regulated compressed air at 4-7 bar (60-100psi)
2. Never exceed maximum and minimum pressure. Too low or too high pressure would cause noise, fast-worn
or misfiring.
3. When connecting air supply always keep hands and body from discharge area of tool.
4. A filter-regulator-lubrication is required and should be located as close to tool as possible.
5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a reduction in power and
efficiency.
6. For better performance, install a quick connector in your tool and quick coupler on the hose if possible.
7.
Be sure all connections in air supply system are sealed to prevent air loss.
Loading fastener and operation
Always disconnect the tool from the compressed air before loading. When loading the tool always point the tool
away from yourself and others. Make sure that you are not holding the tool with trigger depressed while loading
the tool.
1. Insert a strip of fasteners into magazine keeping it point down.
2. Release the latch and pusher, slid the pusher against the nails.
3. Connect the tool to the air supply. Make sure the air pressure is in the correct range denoted in the
Technical Data.
4. Then test the driving depth in a sample piece of wood before using. If the fasteners are being driven too far
or not far enough, adjust the regulator to provide less air pressure or more air pressure.
5. Never operate tool unless safety nose is contact with workpiece. Do not operate tool without fasteners or
damage to tool may result.
6. Never fire fasteners into air because fasteners may injury operator or others and damage to tool may result.
7. The air tool is equipped with safety stand mechanism that disable tool unless safety stand is pushed against
work. Hold gun body firmly and press safety stand on workpiece where fastener is to be applied. Pull the
trigger to drive fastener into workpiece.
8. This operating procedure provides rapid-fire fastener driving. Never operate tool unless safety stand is in
contact with workpiece.