background image

Red = Charging
Green = Fully Charged

CHARGING INDICATOR

www.unilite.co.uk

BLT-1

FEATURES

•  250 Lumen 6500k white COB LEDs

•  With Red 625nm static & flashing modes

•  2 - 30 hours runtime

•  Light is easily removed from hat

•  Built-in USB-A connector with protective cover

•  Directly charged via a USB port

•  High quality 3.7v 420mAh li-po battery

•  Super fast charge time - 1.5 hours

•  IPX5 water resistant

•  Comfortable knitted Beanie, one size fits all

•  Fabric: 35% acrylic 65% polyester

•  Machine washable at 30°C

BATTERY - 3.7v 420mAh Li-polymer Battery 

WEIGHT - 27g (light only)

DIMENSIONS - 73.5 x 41 x 15mm

OPERATION

Switch Sequence: WHITE HIGH > WHITE LOW > RED HIGH > RED 

FLASH > OFF 

(If left in any mode for over 3 seconds, next press will turn OFF) 

CHARGING

1.  Max charging input is 5V 1A.

2.  Remove the rubber cover from the end. 

3.  Plug the USB-A connector directly into a USB charging port 

(do not exceed 5V 1A input or damage may occur). 

4.  Red LED indicates charging, green LED indicates fully charged. 

5.  Charge Time: 1 ½  hrs

**Warranty void if max charging input is exceeded**

ADVICE & IMPORTANT INFORMATION!

Do  not  look  directly  at  LEDs.  Do  not  operate  in  intense  sunlight  or  extreme 

temperature conditions (below -10°C or above 40°C). 

LEDs can become warm/hot when switched on; do not touch and never place 

LEDs face down on any surface – risk of fire! 

Do not use the device if there is any visible damage to the housing, lens, USB 

connector  or  switch. Take  care  when  using  a  USB  plug  adaptor,  check  for  any 

damage.  DO  NOT  exceed  5V  1A  charging  input  or  damage  may  occur  to  the 

internal rechargeable battery.

The rechargeable battery will reach full performance after a few complete charging 

and discharging cycles. 

To keep the rechargeable battery in optimum condition, it shovuld be recharged 

every 3-6 months, especially if it is not being used for a long period of time. Always 

fully charge rechargeable batteries before storage. 

Always  protect  batteries  from  heat,  intense  sunlight,  fire,  water  and  moisture  – 

danger of explosion! 

If  a  battery  is  damaged,  fluids  can  leak  out. AVOID  contact  as  this  can  lead  to 

skin  irritation  and/or  burns.  If  skin  contact  occurs,  rinse  thoroughly  with  water. 

If  irritation  persists,  seek  medical  advice.  Seek  immediate  medical  assistance  if 

battery fluid comes into contact with the eyes.

Children  under  12  years  of  age  should  only  use  the  product  under  adult 

supervision.

Do  not  open,  disassemble  or  attempt  to  modify  the  product;  this  will  void  the 

warranty  and  can  be  dangerous.  Improper  use  or  modification  is  not  covered 

under the warranty.

Take care not to let lenses come into contact with hard/sharp objects, damage/

scratches to lenses will affect light output. 

This product is water resistant to IPX5 – DO NOT SUBMERGE. If the product has 

been subjected to excessive moisture/water the warranty may be void. 

This product has a 1 year standard warranty (or extended 2 years once registered 

online  at  WWW.UNILITE.CO.UK/WARRANTY)  against  manufacturing  faults  and 

defects. It does not cover normal wear and tear, modifications, accidental damage 

or poor maintenance. Unilite warranties do not cover battery leaks or the use of 

incorrect chargers and cables that can damage rechargeable batteries. 

Do not dispose of this device in normal household waste. It must be disposed 

of  via  an  authorised  electrical  appliance  disposal  centre  or  at  your  local  waste 

disposal unit. 

Please re-use or recycle packaging where possible. 

Keep these instructions for future reference or for subsequent possessors.

ANSI FL 1 Standard

White - High

250

Lumen

13 M

2 H

White - Low

70

Lumen

7 M

3½ H

Red - High

15

Lumen

--

4 H

Red - Flash

15

Lumen

--

30 H

ON/OFF

switch

Reviews: