Introduction Front Panel
Set Up Speakon Assembly Operating Modes Protection Features Specifications
Rear Panel
page 5
V-9000 REAR PANEL
PUSH
PUSH
SENSITIVITY
LIMITER
MODE
FILTER 160Hz
LOW CUT 30Hz
BRIDGE
HIGHPASS
ON
OFF
OFF
STEREO
LOWPASS
OFF
ON
ON
PARALLEL
BYPASS
LOW FREQ
ENHANCED
GROUND
K
C
O
L
K
C
O
L
H2
C
H1
C
CH1
CH2
+
+
-
-
+
-
CH1
CH2
BRIDGE
PINOUT
1+
1-
POS NEG
CH 2
PINOUT
2+
2-
POS NEG
CH 2
1+
2+
POS NEG
BRIDGE
1+
1-
POS NEG
CH 1
AC INPUT
~220V 50Hz
OUTPUTS
0.775V
1V
1.44V
Made in Taiwan
Serial No.:
OFF
ON
CH1
CH2
THRU
INPUT
100Hz
19. Filter 160Hz Selector (High-pass, Low-pass, By-pass) -
This three
position switch is used for Subwoofer / Full range / Mid-high range
crossover selection.
20. Limiter -
This switch is used to limit input level. This function can be
used to avoid damage for your speakers.
21. Input Sensitivity Switch -
This three position switch let you select
different input sensitivities, respectively three different voltage gains:
1.44V, 1V or 0.775V.
22. Mode Selection Switch
- This recessed, three-position switch
configures the amplifier for Stereo, Parallel or Bridged Mode
operation. Amplifiers are factory-configured for Stereo Mode. See
section on Mode Selection for more information.
23. Channel 1 XLR THRU Jack -
This Jack is used to send a parallel
signal from the channel 1 input jack to another device or amplifier.
24. Channel 2 XLR THRU Jack
- This Jack is used to send a parallel
signal from the channel 2 input jack to another device or amplifier.
25. Channel 1 Balanced XLR Input Connector
- This connector accepts
input signals on balanced XLR input plug.
XLR pin setting: Pin-3/signal Negative, Pin-2/signal Positive, Pin-1/Ground.
26. Channel 2 Balanced XLR Input Connector
- This connector accepts
input signals on balanced XLR input plug.
XLR pin setting: Pin-3/signal Negative, Pin-2/signal Positive, Pin-1/Ground.
Figure
3
Figure
2
16
24
15
12
14
26
25
23
22
20
19
1
3
10
1
1
21
18
UNiKA
V-8000/V-9000
17
