11. AC Power Cord -
Plug this cable into a standard 110V or 220V wall outlet. Be sure
that the supplied voltage in your area matches the unit's required voltage. Never
plug your power conditioner into a wall outlet that does not match its required
voltage which helps to avoid serious damage may occurred on the unit.
12. XLR lamp connector -
This is used to connect the detachable gooseneck lamp.
13. Power Output (CH1~CH8) -
For CH6~CH8, 3 outlets with wall wart spacing.
REAR PANEL
FEATURES
All PD series models (PD-1/2/3)
8 rear panel outlet and 1 unswitched font panel convenience outlet.
3 outlets with wall wart spacing
Total power capacity of 1800watts
EMI and RFI filtering
Surge and spike protection
Rear XLR lamp connector for gooseneck lamp detachable
Front panel resettable circuit breaker and power illuminated switch
For PD-1
3 additional front panel outlets (total 11 switched outlets, 1 unswitched outlet)
For PD-2
LCD digital voltmeter/ammeters/system clock
Hour and Minute buttons for time set up
For PD-3
LCD digital voltmeter/ammeters/system clock
Hour and Minute buttons for time set up
2 front panel pull-out LED light pipes with front LED on/off switch
Rear light on/off switch for gooseneck lamp
Page 2
MAXIMUM LOAD
The eight circuit breaker protected outlets are rated at 15 amps total, which is equivalent
to 1800 watts at 120 volts. If the total load exceeds 15 amps, the circuit breaker will trip,
cutting off power to your rack. If this happens, reduce the load by unplugging one or
more units from the unit, then push the circuit breaker button in to reset it.
OPERATION
All the PD Series with the same rear panel as below:
PD-1 / 2 / 3
AC IN
LIGHT
~12V 420mA
~120V 50/60Hz
15A
CH8/10A
CH7/10A
CH6/10A
CH5/10A
CH4/10A
CH3/10A
CH2/10A
CH1/10A
TOTAL MAX 15A
13
11
12