Unigas PBY93, Manual For Use, Installation And Maintenance

Page: 101 / 134

49
RESTORE PARAMETER FROM AZL2x TO LMV..
To copy the previously saved configuration on AZL2x proceed as follows:
access up, press
F
and
A
at the same time
enter the password following the procedure on chapter “Programming LMV2x”.
Press ENTER until the display will show:
With the buttons go to the group
100
of the parameters, press на and always with the buttons
+
and
-
go to
113
parameter "Burner ID", press and verify (and/or change with buttons by pressing enter to confirm)
iWith the buttons go to the group
000
of the parameters, press end select the
050
parameter
press the disply show with the button the display shows
press again with the button
+
select
1
and start the restore process by pressing .
After about 5 seconds the restore process ends and the display shows .
Now, LMV has the same configuration that was stored on AZL2x.
To copy the configuration from AZL2x to LMV. It is important that the type of LMV is the same (for example LMV20
with LMV20, etc.) and that 113 "Burner ID" of the burner is the same value that is saved in the configuration you
want to copy.