Unigas P91A, Manual

Page: 137 / 167

M12927CA
con Group - Consumption parameters
Liv N° Param
Description Values
Default
C 134 Co.tY Count type oFF = Not used
1 = Instantaneous power (kW)
2 = Power consumption (kW/h)
3 = Energy used during program execution. This
measure starts from
zero when a program runs end stops at the end
of the program. A
new program execution will reset the value
4 = Total worked days: number of hours the
instrument is turned ON
divided by 24.
5 = Total worked hours: number of hours the
instrument is turned ON.
6 = Total worked days with threshold: number of
hours the instrument is
turned ON divided by 24, the controller is forced
in stand-by when
Co.ty value reaches the threshold set in [137]
h.Job.
7 = Total worked hours with threshold: number of
hours the instrument
is turned ON, the controller is forced in stand-by
when Co.ty value
reaches the threshold set in [137] h.Job.
8 = Totalizer of control relay worked days:
number of hours the control
relay has been in ON condition, divided by 24.
9 = Totalizer of control relay worked hours:
number of hours the control
relay has been in ON condition.
10 = Totalizer of control relay worked days with
threshold: number of
hours the control relay has been in ON condition
divided by 24,
the controller is forced in stand-by when Co.ty
value reaches the
threshold set in [137] h.Job.
11 = Totalizer of control relay worked hours with
threshold: number of
hours the control relay has been in ON condition,
the controller is
forced in stand-by when Co.ty value reaches the
threshold set in
[137] h.Job. oFF
C 138 t.Job Worked time (not resettable) 0... 9999 days 0
cAL Group - User calibration group
Liv N° Param
Description Values
Default
C 139 AL.P Adjust Low Point From -1999 to (AH.P - 10) in engineering units 0
C 140 AL.o Adjust Low Offset -300... +300 (E.U.) 0
C 141 AH.P Adjust High Point From (AL.P + 10) to 9999 engineering units 999.9
C 142 AH.o Adjust High Offset -300... +300 0
14