SHB_PNG05.fm
A31003-G2100-S100-2-7620, 03/2014
PNG Configuration for Gigaset M2
plus
and M2 Ex professional, Service Manual
10
PNG-S in Gigaset Base
5
PNG-S in Gigaset Base
The Gigaset S310 ISDN base is connected to an ISDN port of the HiPath 3000 or HiPath 4000.
The handset is configured as a personal alarm device at this base.
The handset operates without a control centre when working in Gigaset base (unless Gigaset
base does not support the required CLIP protocol).
You can choose how to set the PNG parameters and configure the handset to suit your require-
ments.
Monitoring is activated directly by the handset.
The alarm functions are not tested. However, you can check the alarm function when monitor-
ing is active by triggering the relevant alarm event.
PNG-S alarm calls are routed to the alarm destination set.
In order to ensure that the alarm calls reach the alarm destination they are repeated until the
alarm call count has been reached or until alarm repetition has been interrupted manually on
the handset.
It is not possible to call back the central office to end repetition of the alarms due to failure of
CLIP transmission (in the Setup message). Bear this in mind when configuring the number of
alarm repetitions.
Monitoring is deactivated directly on the handset.
Restrictions
It is not possible to send an alarm signal to an internal station on the base.
Despite alarm repetitions, there is no guarantee that all alarm calls will reach the programmed
destination.
Configuration tip
To ensure that the PNG-S can start up without PNEZ, the "PNEZ Basis" parameter must be
deleted from the PNG configuration. See also Section 7.2.1.2, “PNEZ Basis (Number Config-
ured)” and Section 7.2.1.3, “PNEZ Basis (Number Deleted)”.
7
This type of operation does not conform to BGR 139.
7
Ensure that no other handsets operating in conjunction with the base are able to
block the line.
