64 Bays SAS to SAS/SATA JBOD Subsystem
User Manual
39
3.5 Powering On
1.
Plug in all the power cords into the AC Power Input Socket located at the PSFM.
NOTE: The subsystem is equipped with redundant, full range
power supplies with PFC (power factor correction). The system
will automatically select voltage.
NOTE: The PSFM has a 5V standby DC voltage. When the power
cord(s) is/are connected to the AC Power Input Socket, after 1
second, all Activity LEDs will flash once. When the power cord(s)
is/are disconnected from AC Power Input Socket, after 3 seconds,
all Activity LEDs will flash twice.
2.
Turn on each Power On/Off Switch of the PSFM. The main switch button in the
front panel will still flashing blue.
NOTE: When the power cord connected from main power source is
inserted to the AC Power Input Socket, the Power Status LED
becomes
RED
. When the switch of the PSFM is turned on, the LED
still shows
RED
. After the main switch in front panel is turned on,
the LED turns
GREEN
, which means it is functioning normally.
Power Supply 1 Power Supply 2
