UNIFLEX-Hydraulik – 16 – www.uniflex.de
Cutting of Hoses
The blade protection opens and closes automatically with each cutting process.
Warning:
Never operate the blade protection by hand!
Cutting without pneumatic feeder ( EM 1 / EM 2 / EM 3.3 / EM 3.2 Ecoline )
•
Prepare the machine as shown above.
•
Mark the desired cutting length.
•
Start the machine by turning the main switch to «I».
•
Place the hose line in front of the holding pins on the cutting support.
•
Hold the hose ends, tense with the hand lever and at the same time pull / push the hose assembly through.
•
After cutting the hose line, put the hand lever back to its original position.
•
Take out hose pieces.
•
By turning the main switch to position «O» switch the machine off.
Cutting with EM 3.4 DC
•
Wear ear protection.
•
Cut as shown
<
cutting without pneumatic feeder>.
•
Don´t operating with gel batteries
•
Make sure the Batteries are protected for overloading.
•
Use sufficient dimensioned Batteries
•
Don´t cut several hose line one after another.
Summary of Contents for EM 1
