background image

OM-RANSERVE MOBILE SERVING

INSTALLATION

CAUTION:  THIS UNIT CONTAINS R290 FLAMMABLE REFRIGERANT.  SEE ABOVE CAUTION. 
CAUTION:  UNIT MUST BE INSTALLED INTO IT’S OWN COMPARTMENT TO PROPERLY 

CONTAIN ANY REFRIGERANT LEAK.  IT IS REQUIRED THAT NO ARCHING 

POTENTIAL COMPONENTS (GFCI) OR ELECTRICAL CONNECTIONS ARE 

BELOW 14.5” FROM THE BOTTOM OF THE CABINET. 

WARNING:  FAILURE TO FOLLOW INSTALLATION GUIDELINES AND RECOMMENDATIONS 

MAY VOID THE WARRANTY ON YOUR UNIT.

WARNING: IT IS IMPORTANT THAT YOUR UNIT HAS ITS OWN DEDICATED LINE. 

CONDENSING UNITS ARE DESIGNED TO OPERATE WITH A VOLTAGE 

FLUCTUATION OF PLUS OR MINUS 10% OF THE VOLTAGE INDICATED ON 

THE UNIT DATA TAG. BURN OUT OF A CONDENSING UNIT DUE TO EXCEEDING 

VOLTAGE LIMITS WILL VOID THE WARRANTY.

 

THE DANFOSS CONTROLLER HAS LOW VOLTAGE PROTECTION AND WILL NOT 
OUTPUT VOLTAGE TO THE COMPRESSOR IF VOLTAGE IS LESS THAN 104V.

WARNING:  IT IS IMPORTANT THAT A VOLTAGE READING BE MADE AT THE COMPRESSOR 

MOTOR ELECTRICAL CONNECTIONS, WHILE THE UNIT IS IN OPERATION 

TO VERIFY THE CORRECT VOLTAGE REQUIRED BY THE COMPRESSOR IS 

BEING SUPPLIED.  LOW OR HIGH VOLTAGE CAN DETRIMENTALLY AFFECT 
OPERATION AND THEREBY VOID ITS WARRANTY.

WARNING:  THIS UNIT IS INTENDED FOR USE IN LABORATORIES IN COMMERCIAL, 

INDUSTRIAL, OR INSTITUTIONAL OCCUPANCIES AS DEFINED IN THE 

SAFETY STANDARD FOR REFRIGERATION SYSTEMS, ASHRAE 15. 

SELECTING A LOCATION FOR YOUR NEW UNIT

The following conditions should be considered when selecting a location for your unit:
1. 

Floor:

  The area on which the unit will rest must be level, free of vibration, 

and suitably strong enough to support the combined weights of the unit plus 
the maximum product load weight.

2. 

Clearance: 

 Do not place any object that can block the ventilation exhaust 

from the machine compartment register.  20 inch clearance at the louvered 
end of the unit.  Area of  equipment must be free of all combustible materials.

3. 

Ventilation: 

 Avoid surrounding your unit around other heat generating 

equipment and out of direct sunlight. Avoid locating in an unheated room or 
where the room temperature may drop below 70° F (21°C) or above 86°F 
(32°C).

ELECTRICAL SUPPLY

The wiring should be done by a qualified electrician in accordance with local electrical 
codes. A properly wired and grounded outlet will assure proper operation. Please 
consult the data tag attached to the compressor to ascertain the correct electrical 
requirements. Supply voltage and amperage requirements are located on the serial 
number tag.

INSTALLATION CHECKLIST

After the final location of the unit has been determined refer to the following checklist 
prior to start up:
1.   Check all exposed refrigeration lines to ensure that they are not kinked, dented or  

rubbing together.

2.   Check all visible components for any potential damage.
3.   Check that condenser fans rotate freely without striking any stationary members.
4.   Unit must be properly leveled.
5.   Unit must be property leveled; Check all legs or casters ensure they all are in 

contact with the floor while maintaining a level work surface. Adjusting bullet 
feet height or shimming casters may be necessary if the floor is not level. NOTE: 
Damage to equipment may result if not followed. Unified Brands is not responsible 
for damage to equipment in improperly installed.

6.   Plug unit into power source. Unit will come on. If unit does not turn on, refer to 

controller operation section of this manual to manually turn on the unit.

7.   Allow unit 50-60 minutes to cool down to temperature. If temperature adjustments 

are required, refer to controller operation section of this manual to adjust the 
temperature. Confirm that the unit is holding the desired temperature.

8.   Refer to the front of this manual for serial number location. Please record this 

information in your manual now. It will be necessary when ordering replacement 
parts or requesting warranty service.

IMPORTANT - READ FIRST - IMPORTANT

INTERIOR EVAPORATOR COVER

EXTERIOR OF UNIT

RISK OF FIRE OR EXPLOSION. 

FLAMMABLE REFRIGERANT USED. 

DO NOT USE MECHANICAL DEVICES 

TO DEFROST REFRIGERATOR. DO NOT 

PUNCTURE REFRIGERANT TUBING.

RIESGO DE INCENDIO O EXPLOSIÓN. REFRIGERANTE INFLAMABLE UTILIZADO. NO 

UTILICE DISPOSITIVOS MECÁNICOS PARA DESCONGELAR EL REFRIGERADOR. NO 

PERFORE LA TUBERÍA DEL REFRIGERANTE.

RISQUE D’INCENDIE OU 

D’EXPLOSION. 

INFLAMMABLE 

RÉFRIGÉRANT UTILISÉ. 

NE PAS UTILISER DE 

DISPOSITIFS 

MÉCANIQUES POUR 

DÉGIVRER LE 

RÉFRIGÉRATEUR. NE 

FAIRE AUCUN TUBE 

RÉFRIGÉRANT DE 

PONCTION.

DANGER

SB6.1.2

WARNING          ALERTE

CAUTION ATTENTIÓN

DO NOT REMOVE PANEL - HIGH VOLTAGE -

QUALIFIED PERSONNEL ONLY

NE PAS RETIRE LE PANNEAU - HAUTE TENSION -

PERSONNEL QUALIFIÉ SEULEMENT

NO RETIRE EL PANEL - ALTA TENSIÓN - 

CALIFICADO PERSONAL

MOVING PARTS, DO NOT OPERATE 

WITH COVER REMOVED

PIÉCES MOBILES NE PAS FAIRE 

FONCTIONNER SANS COUVERCLE

LAS PIEZAS DE MOVIMIENTO NO FUNCIONAN 

CON LA CUBIERTA RETIRADA

PP LBL1701 REV B

LABEL DIMENSION:  9 in x 3.25 in 

RISK OF FIRE OR EXPLOSION. 

DISPOSE OF PROPERLY IN 

ACCORDANCE WITH FEDERAL OR 

LOCAL REGULATIONS. 

FLAMMABLE REFRIGERANT USED.

PRECAUCIÓN 

RIESGO DE INCENDIO O EXPLOSIÓN. DESÉCHELO ADECUADAMENTE CONFORME 

A REGLAMENTOS FEDERALES O LOCALES. REFRIGERANTE INFLAMABLE UTILIZADO.

MISE EN GARDE

 RISQUE 

D’INCENDIE OU 

D’EXPLOSION. ÉLIMINER 

(or DISPOSER) 

CORRECTEMENT 

CONFORMÉMENT AUX 

RÉGLEMENTATIONS 

FÉDÉRALES OU LOCALES. 

RÉFRIGÉRANT 

INFLAMMABLE UTILISÉ.

SB6.1.4 

LABEL DIMENSION:  6 in x 2.75 in 

PP LBL1704 REV B

CAUTION

RISK OF FIRE OR EXPLOSION DUE TO 

PUNCTURE OF REFRIGERANT TUBING; FOLLOW 

HANDLING INSTRUCTIONS CAREFULLY. 

FLAMMABLE REFRIGERANT USED.

PRECAUCIÓN 

RIESGO DE INCENDIO O EXPLOSIÓN DEBIDO A LA PERFORACIÓN DE LA TUBERÍA DE 

REFRIGERANTE; SIGA CUIDADOSAMENTE LAS INSTRUCCIONES DE MANEJO. REFRIGERANTE 

INFLAMABLE UTILIZADO.

MISE EN GARDE

 RISQUE 

D’INCENDIE OU 

D’EXPLOSION EN RAISON 

DE LA PERFORATION DU 

TUBE RÉFRIGÉRANT; 

SUIVEZ ATTENTIVEMENT 

LES INSTRUCTIONS DE 

MANIPULATION. 

RÉFRIGÉRANT 

INFLAMMABLE UTILISÉ.

CAUTION

SB6.1.5

PP LBL1705 REV B

LABEL DIMENSION:  6.25 in x 2.8 in 

RISK OF FIRE OR EXPLOSION. FLAMMABLE 

REFRIGERANT USED. CONSULT REPAIR MANUAL 

/ OWNER’S GUIDE BEFORE ATTEMPTING TO 

INSTALL OR SERVICE THIS PRODUCT. ALL 

SAFETY PRECAUTIONS MUST BE FOLLOWED. 

PRECAUCIÓN 

RIESGO DE INCENDIO O EXPLOSIÓN. REFRIGERANTE INFLAMABLE UTILIZADO. CONSULTE EL MANUAL DE REPARACIÓN / 

MANUAL DEL USUARIO ANTES DE INSTALAR O REPARAR ESTE PRODUCTO. DEBEN SEGUIRSE LAS PRECAUCIONES DE SEGURIDAD.

MISE EN GARDE 

RISQUE 

D’INCENDIE OU 

D’EXPLOSION. RÉFRIGÉRANT 

INFLAMMABLE UTILISÉ. 

CONSULTER LE MANUEL DE 

RÉPARATION / GUIDE DE 

L’UTILISATEUR AVANT 

D’ESSAYER D’INSTALLER OU 

DE RÉPARER CE PRODUIT. 

TOUTES LES PRÉCAUTIONS 

DOIVENT ÊTRE RESPECTÉES.

SB6.1.3.b 

PP LBL1703 REVB

LABEL DIMENSION:  7.5 in x  5.36 in

SB6.1.3.a 

RISK OF FIRE OR EXPLOSION. FLAMMABLE 

REFRIGERANT USED. TO BE REPAIRED ONLY 

BY TRAINED SERVICE PERSONNEL. DO NOT 

PUNCTURE REFRIGERANT TUBING.

PELIGRO 

RIESGO DE INCENDIO O EXPLOSIÓN. REFRIGERANTE INFLAMABLE UTILIZADO. DEBE SER REPARADO 

SOLAMENTE POR PERSONAL DE SERVICIO CAPACITADO. NO PERFORE LA TUBERÍA DEL REFRIGERANTE.

DANGER 

RISQUE 

D’INCENDIE OU 

D’EXPLOSION. 

RÉFRIGÉRANT 

INFLAMMABLE UTILISÉ. 

POUR ÊTRE RÉPARÉ QUE 

PAR UN TECHNICIEN 

QUALIFIÉ. NE PAS 

PERFORER LE TUBE 

RÉFRIGÉRANT.

CAUTION

DANGER

NEAR EXPOSED REFRIGERANT TUBING

NEAR MACHINE COMPARTMENT AND NAMEPLATE

Summary of Contents for Randell RAN SCA-2














Reviews: