OM-HY/6E 9
CONTROLS
Operator controls are on the front right of the unit. The control panel has the following
touch pads and indicator lights:
The timer is used in three ways:
1. The ON/OFF touch pad gets the HyPerSteam ready for use, or shuts it off.
2. The READY indicator light shows that the steam generator is at standby
temperature and the cavity is hot enough to begin steaming.
3. When one probe is covered with lime scale or fails, the
DELIME light flashes briefly every few seconds, but the
unit will continue to operate. Delime the unit as soon
as possible. The DELIME light will flash until power is
removed from the unit, or the unit goes through a clean
cycle.
4. If the problem continues, both probes may fail. Then the
steamer stops working, and the SERVICE light is lit. If
DELIMING/CLEANING does not correct, turn off the power
and contact an Authorized Groen Service Representative
for repair.
5. The DELIME indicator light is lit when the unit is operating
in the cleaning mode.
6. The HI TEMP indicator light comes on when the steam
generator is too hot. The unit will automatically shut off,
and cannot be turned on again until the steam generator
cools and the HI TEMP indicator light goes out.
7. The TIMING indicator light stays on when the timer is
running.
8. The CLEAN touch pad is used to start the automatic 50
minute deliming cycle.
9. The timer is used in three ways:
a. In the OFF position the steam generator stays at a low boil
or “holding” temperature.
b. When a cook time is set, the unit steams until the timer runs down to OFF. At
that time steaming stops, a red light comes on and a beeper sounds.
c. With the timer turned to the ON position, the unit steams continuously. The
green light stays lit. The steamer will not time down.
Operation
WARNING
ANY POTENTIAL USER OF THE EQUIPMENT
SHOULD BE TRAINED IN SAFE AND CORRECT
OPERATING PROCEDURES.
WARNING
WHEN YOU OPEN THE DOOR, STAY AWAY
FROM THE STEAM COMING OUT OF THE
UNIT. THE STEAM CAN CAUSE BURNS.