4
Registering the Repeater
If the base has an LCD display, open the menu on the base when
1.
the phone is not in use and select
Register Handset
. If the base
DOES NOT have an LCD display, press and hold
FIND
on the base
when the phone is not in use (about 5 seconds).
2. On the bottom of the repeater,
press and hold the registration
button until the
LINk
light starts to
blink (about 2 seconds).
Release the button and wait for the
3.
LINk
light to turn on and steady (this
can take about 90 seconds).
If the
LINk
light
doesn't turn
on, disconnect
the repeater's
AC adapter.
Wait about ten seconds, then try these steps
again.
Some important things to remember:
Only register one repeater at a time. If
more than one repeater is in registration
mode at the same time, they can interfere
with each other.
If you want to use the repeater with a different base, just register
the repeater to the new base. The repeater automatically erases
the link to the old base when it registers to the new one.
Only register repeaters to one base at a time. If more than one
base is in registration mode at the same time, you can't control
which base the repeater registers to.
Placing the Repeater
Here are a few tips for placing your repeater so that you get the
clearest signal and the maximum range:
Make sure you have good reception from the base.
Put the repeater
at least 10m
away from the base or any other
repeater. (If you put the repeater on a different floor from the
base, don't forget to allow 10m vertically, also.)
If possible, mount the repeater on the wall.
XDECT R001 OM.indd 4
22/9/11 11:31:02 AM
