47
Registering Repeaters to the Base
If you are having trouble with a repeater or if you want to replace one,
you need to register the repeater to the base.
Connect the repeater close to the base for easy access to the
necessary buttons and indicators. Locate the repeater in the
desired position after registration is complete.
On the base, open the menu and select
1)
Register Accy.
On the back of the repeater you want to register, press and hold
2)
the registration button until the
LINk
light on the front starts to
blink (about 2 seconds).
Release the button and wait for the
3)
LINk
light to turn on and
steady (this can take about 90 seconds). The repeater has been
registered to the base.
If...
Try...
the
LINk
light
won't turn on
checking the repeater's AC adapter
-
connecting the adapter to a different outlet.
-
the
LINk
light
continues
flashing
disconnecting the unit's AC adapter. Wait about ten
-
seconds, then try again.
making sure there are not already 6 repeaters registered
-
to this base.
making sure no other base or repeater is in registration
-
mode.
Only register one repeater at a time. If more than one repeater is
in registration mode at the same time then they can interfere with
each other.
Only register a repeater to one base at a time. If more than one
base is in registration mode at the same time then you can't
control which base the repeater registers to.
If you want to register two repeaters to this base, just repeat these
steps with the second repeater.
XDECT 8055 OM.indb 47
12/8/11 3:02:59 PM
